Water Heater Replacement calls from Broomfield start the same way: what's happening, what kind of house is it, and where are you? Then you'll hear whether your address is covered. That goes for the original Broomfield Heights, Anthem and everywhere else in Broomfield. Replacing a water heater in a Broomfield basement or closet means getting the vent, gas connection, relief valve and permit right, along with any high-altitude setup the manufacturer requires. A like-for-like tank swap is usually simple. Changes in size or type take more planning.
Safe checks before you call from Broomfield
- If you smell gas, leave and call Xcel Energy or 911 from outside.
- If the heater leaks, close the cold supply valve on top.
- Turn a gas heater to pilot or off, or switch off an electric heater's breaker.
- Write down any error code and the model and age from the label.
When to replace
Water from the tank body, rust at the base, rusty hot water, loud rumbling, and a heater past about ten years needing a major part. In finished basements, replacing before a leak saves flooring and drywall.

Sizing and type
Most households use a 40- or 50-gallon tank. Larger households may want more capacity, a tankless unit or a high-efficiency model. ENERGY STAR explains efficiency ratings. New tanks can be larger than old ones of the same capacity, which matters in closets.
Water still running or not sure what to do next? Call.
Call 000 000 0000Venting changes
Gas water heaters that share a chimney with a furnace may need a liner or vent changes when either appliance is replaced, especially when moving to high-efficiency equipment. Power-vent and condensing models use different venting. The provider should check the vent as part of the job.
Permits in Denver and the suburbs
Water heater replacement generally needs a permit. In Denver, many common residential projects go through Quick Permits. Suburbs and Douglas County have their own building departments. Ask the provider to pull the permit and schedule inspection.
What the job includes
Draining and removing the old heater, setting the new one, connecting water, gas or power, installing a relief valve and discharge pipe, checking or replacing the vent connector, adding an expansion tank where needed, leak testing and haul-away. Confirm what's included.
Expansion tanks
Closed systems need an expansion tank, which is often required with replacement.
Water heaters at Denver's altitude
Most Denver-area water heaters are gas tanks in a basement or utility room, often sharing a vent with the furnace. Electric tanks and tankless units are common too, especially in newer homes. At about a mile high, gas appliances need high-altitude setup per the manufacturer, and a burner that's set up wrong can burn poorly, soot up or produce more carbon monoxide. Incoming water is very cold in winter, so heaters work hardest just when you need them most.
Most repairs come down to a failed part: a thermocouple, flame sensor, igniter, gas valve, element, thermostat or relief valve. A tank leaking from its body needs replacing. Replacements and tankless installations generally need a permit, partly because venting and gas connections are safety-critical. Keep carbon monoxide alarms on every level, and if you ever smell gas, leave and call Xcel Energy or 911 from outside.
Good questions to ask about water heater repair in Broomfield
- Is this heater worth repairing at its age?
- Is it set up correctly for high altitude, and is the vent drawing properly?
- Does the work need a permit, and who arranges the inspection?
- What size and type would you suggest if it needs replacing?
Mistakes to avoid
Avoid relighting a pilot when you smell gas, capping or plugging a dripping relief valve, ignoring soot around the draft hood, and installing a replacement without a permit. Relief valves, venting and gas connections are safety parts, not places to improvise.
Water Heater Replacement in Broomfield: local notes
Broomfield began with 1950s Broomfield Heights ranches and grew into large newer neighborhoods such as Anthem and the Broadlands. Broomfield is a combined city and county, so permits and utilities run through one local government.
Water in Broomfield comes from the City and County of Broomfield's water utility. Permits come from the building department for the City and County of Broomfield. Gas service in most of the metro is from Xcel Energy, and any digging needs Colorado 811 locates first.
Landmarks near you
Near FlatIron Crossing, the shopping center off US 36, or closer to Broomfield County Commons Park, the large park and open space on the north side? The call is the same: describe the problem, share your cross streets and ask whether you're covered. See FlatIron Crossing.
Handy when you call
- Current size, fuel and age
- Location and space around the heater
- Whether it shares a vent with the furnace
- Interest in tankless or high-efficiency
- Your Broomfield address or nearest cross streets
The steps
- Call the number on this page.
- Describe the problem and anything you've switched off.
- Give your Broomfield cross streets and ask whether you're covered.
- Ask about pricing and permits. The provider sets prices, not this website.
More for Broomfield
- Plumbing help in Broomfield: housing, utilities and permits
- Water Heater Repair in Broomfield
- Tankless Water Heater Installation in Broomfield
- No Hot Water in Broomfield
- All water heater repair in Broomfield
- Water Heater Replacement nearby: Westminster, Thornton, Arvada, and Denver
- Guide: When Denver Plumbing Work Needs a Permit
