Water spraying? Close the main shutoff first. Smell gas? Leave and call Xcel Energy or 911 from outside.
Call 000 000 0000

Denver metro · phone only

Burst Pipe Repair for Aurora homes

Burst Pipe Repair for Aurora homes. Phone only.

Call now 000 000 0000Placeholder number while the live line is set up.
  • No forms
  • Burst pipes
  • Sewer backups
  • Water heaters
Illustration of burst pipe repair for a Aurora, CO homeIllustration

Last updated

For burst pipe repair in Aurora, CO, one call gets things moving. Explain what you're seeing, what you've shut off, and ask whether your Aurora address is covered. We hear from Saddle Rock and Hoffman Heights often. When a pipe bursts in a Aurora home, every minute the water runs adds damage, so close the main water shutoff before anything else. Then open a low faucet to drain the lines, keep clear of wet electrical, and call. The repair itself is usually straightforward once the break is found. The bigger job is often drying out.

First steps

  1. Close the main water shutoff right away.
  2. Open the lowest faucet in the house to drain pressure from the pipes.
  3. Switch off power to wet areas only if you can reach the panel without standing in water.
  4. Move belongings and take photos for insurance.

Why pipes burst around Denver

Freezing is the leading cause on the Front Range. Water expands as it freezes, and pressure builds between the ice and a closed faucet until a fitting or pipe wall splits. Other causes include corroded galvanized pipe in older homes, failed fittings, high water pressure, water hammer and physical damage during remodeling. Washing machine hoses and toilet supply lines also fail suddenly and flood rooms just as fast as a split pipe.

Supporting illustration of burst pipe repair in Aurora, Colorado
Illustration, not a photo of a specific provider or job.

Finding the break

Sometimes the break is obvious: water spraying in an unfinished basement or a crawlspace. Often it's hidden in a wall or ceiling, and water shows up somewhere else, like a stain on a ceiling below or a puddle at a baseboard. The provider traces the leak from where water appears, checks likely spots like exterior walls and unheated areas, and may open drywall to reach it. Opening a small, targeted area is better than guessing.

Water still running or not sure what to do next? Call.

Call 000 000 0000

How burst pipes are repaired

Copper is usually repaired by cutting out the damaged section and soldering or pressing in new pipe and fittings. PEX is repaired with crimp or expansion fittings. Galvanized steel in older homes is often replaced with copper or PEX at the damaged section, and a provider may suggest planning a larger repipe if the pipe is badly corroded. After the repair, the system is pressurized and checked for other leaks, especially after a freeze, when more than one spot can crack.

Drying out and preventing mold

Water soaks into drywall, insulation, subfloor and carpet pad. Surface drying isn't enough. Professional water mitigation companies use moisture meters, fans and dehumidifiers to dry structures and reduce mold risk. Denver's dry air helps, but saturated materials in a basement can stay wet for a long time. Take photos before cleanup, call your insurer early and keep receipts.

Stopping it from happening again

If the pipe froze, address the cause: insulate pipes in crawlspaces and exterior walls, seal drafts, disconnect hoses in fall, and keep the heat on when you travel. If corrosion caused it, ask about the condition of the rest of the piping. A provider can check water pressure, too. Pressure that's too high stresses every joint in the house, and a pressure-reducing valve can fix it.

Why emergencies hit Denver homes the way they do

Most Denver-area houses have basements or crawlspaces, and that's where emergencies tend to show up first: a split pipe along a rim joist, sewage at the floor drain, water around the base of the water heater. Front Range winters bring sudden arctic cold after mild weeks, so freeze damage clusters in a few days each winter, often showing up as pipes thaw. Older homes add galvanized supply pipe, cast iron drains and clay sewer laterals, all of which fail with age. The common thread is that the first few minutes matter: knowing where the main shutoff is, keeping away from water near electrical equipment and leaving the house at once if you smell gas.

Once the immediate danger is handled, the repair itself is usually ordinary plumbing work: replacing a split section, clearing and inspecting a sewer line, or repairing gas piping after the utility has made things safe. Many of those repairs need a permit and inspection, and some, like sewer lateral repairs under a street, involve the city as well. Asking about permits on the first call avoids surprises later.

Good questions to ask about emergency plumbing in Aurora

  • Is the water, gas or sewage situation safe to wait on, and what should I keep shut off?
  • What caused the failure, and are other pipes or fittings at risk?
  • Will the repair need a permit or a utility to be involved?
  • How is the work priced, and what happens if more damage turns up?

Mistakes to avoid

Common mistakes make emergencies worse: forcing a seized main valve until it breaks, walking into water near outlets, using a torch to thaw a frozen pipe, running more water during a sewer backup, or going back inside to look for a gas leak. Shut off what you safely can, stay clear of hazards and call.

Burst Pipe Repair in Aurora: local notes

Aurora has 1950s and 1960s ranches in Original Aurora and Hoffman Heights, big 1970s to 1990s subdivisions with full basements, and new homes on the east side. Aurora runs its own water utility, so meter, curb-stop and water main questions go to Aurora Water, not Denver Water.

Water in Aurora comes from Aurora Water. Permits come from the building department for the City of Aurora. Gas service in most of the metro is from Xcel Energy, and any digging needs Colorado 811 locates first.

Landmarks near you

Near Stanley Marketplace, the converted aviation factory near Central Park, or closer to the Anschutz Medical Campus, the hospital and university campus on the old Fitzsimons base? The call is the same: describe the problem, share your cross streets and ask whether you're covered. See Stanley Marketplace.

Handy when you call

  • Whether the main water is off
  • Where water is showing up
  • Pipe type if you know it: copper, PEX or galvanized
  • Whether it happened after a cold night
  • Your Aurora address or nearest cross streets

The steps

  1. Call the number on this page.
  2. Describe the problem and anything you've switched off.
  3. Give your Aurora cross streets and ask whether you're covered.
  4. Ask about pricing and permits. The provider sets prices, not this website.

More for Aurora

Aurora: Burst Pipe Repair FAQ

How long does a burst pipe repair take?

Repairing an accessible pipe is often fairly quick. Hidden pipes take longer because walls or ceilings have to be opened. Drying and restoring drywall and flooring takes the most time and is usually done by separate mitigation and restoration companies.

Will homeowners insurance cover a burst pipe?

Many policies cover sudden water damage from a burst pipe, but terms vary, and damage from neglect or gradual leaks may be excluded. Call your insurer, document everything and keep receipts. We don't give insurance advice.

Can a burst pipe be temporarily patched?

Clamps and repair couplings can stop a leak temporarily, but a permanent repair replaces the damaged section. Keep the water off until a proper repair is made if you can.

What do I do if a pipe bursts in my Aurora home?

Close the main water shutoff right away, then open a low faucet to drain the pipes. Keep away from water near electrical outlets and appliances. Move valuables, take photos and call the number on this page. If you can't find or close the main shutoff, your water provider can shut off water at the curb stop.

Does burst pipe repair in Aurora need a permit?

It depends on the work. Simple repairs often don't, while replacements and line work generally do. Permits come from the building department for the City of Aurora, not Denver.

Who do I call about the water main or meter in Aurora?

Water service comes from Aurora Water. They handle the main and meter. Problems on your side, including burst pipe repair, are generally the owner's to repair.

Map of Aurora, Colorado

City-level map for orientation only. This line has no public office or street address.

Denver-area plumbing, one call away

Calling from Aurora? Describe the problem, ask whether your address is covered, and hear the next step. Call to check availability.

Call 000 000 0000
Plumbing problem in the Denver area?Call 000 000 0000